How to make wooden clock

1. Intro: Hi, I am jam sheets, Welcome to my training course. In this short course, I want to teach you how to make your beautiful wooden clock. A clock that you can make in the shortest possible time and does not require any background. The construction steps fully explain them. And at the end of the course, we will be appreciated to make the most beautiful wooden clubs and be surprised by the results. So join me. 2. 1 material: The first material needed is good. Here we have used wallah would with approximate dimensions of 12 by 12 in a thickness of four centimeter. The steps of preparation are taught in the next video. The next device required is the wall clock motto, which is selected from the lungs road type. Clock hands can be selected from any type and it is quiet. I'll let the dimensions of the hands should be a small soft sandpaper and still are also used to send the wood surface. Finally, we used linseed oil to beauty the wood and make the mu2 phase waterproof. 3. 2 wood preparation: In this video, you watched it. Steps of would-be operation, which is first caught, then the ids of the wood around it, and finally the surface afterwards sanded? Yeah. Mm-hm. 4. 3 mark center: At this stage, we are going to mark the center of the old. First off, the mood that is more beautiful as the back of the watch. Then use a ruler to find the center off the road and market to be ready for the next step. 5. 4 drill part 1: To drill a hole in root, we must first drill a hole the size of the motor root. For this purpose, we use an IDE on drew into numbers. One, decides are folk, Khaled, motto, route and other smaller, small beat to do at home. Using a larger meets increased. And so the whole watch multiple. Okay. 6. 5 drill part 2: After doing the center of the roots, you create the motto cavity. Using the number eight would boring, Great. Just be careful not to drill to the boring stuff about five millimeter to the end of the word. Finally, we tested Gulag motto inside there. 7. 6 sanding: Using sandpaper number three hundred, six hundred and eight hands with you stand the ITO suface off the root. 8. 7 lubricate wood: After sending, it is time to lubricate the surface of the standard looked at this is stage. We first clean the surface of the moon. Our lubricate the surface of the moon using our finger. We used linseed oil to lubricate the surface. Finally, kinda excess oil on the surface. 9. 8 last step: In the last step, we are going to connect the motor ads. As you can see in the tutorial video, we do all the steps carefully and patiently. The hands are made of plexiglass, which would connect first our hands and ten. Finally, we're sticking around. The construction of this food they'd lock has been completed. I hope you enjoy watching these thoughts are albedo and make beautiful watches.