Practical Rhino: Construction-Ready Parametric Wall

Projeto prático de curso

the decorative wall that was used in the videos was just one application of the process. there are many decorative designs that are made with parallel sections. the park bench below is a good example:

try modeling this bench and see if any new challenges arise. of course, a difficult part is thinking about the connections between the pieces.

a similar challenge arises if we change our decorative wall a little. instead of being glued or bolted to the wall behind it, suppose it's a standalone wall in a public space. now we need to fix it on the ground and also connect the pieces so that they remain fixed at the top as well. we can make holes in the pieces and pass rods through them. here is how it would look:

if we use the contour command, now each section has more than one curve, which can be problematic further down the road when we use distribute or boxedit. test this and see the exact problem that occurs. hint: you don't have to add the holes in the model. you can add them after all the other steps. you just have to make sure they are placed in the exact same location in each section. 

see how it works and upload the results!